Not too much to report here. I've reinforced the area below the window with some epoxy applied to the back to give some of the shallow details something to rest against.
The headlight holes have been drilled. They are a bit small but once I decide the lighting method I'll widen them.
I've attached the arm slots too. This was trickier that it looks since there was a lot of material I had to remove from the holes. I also had to make sure that they were as straight as possible before gluing. I could have used a third arm!
My first major assembly was the back section to the base. I used squadron white putty on the seams and sanded it smooth (I tried to shoot it here but my web cam just can't capture it). I'm going to add a bearing to the top circular notch to hang the door from rather than leave it as Scott intended.
The exhaust hole on the base will be covered by some black styrene and I will put the electrical connection point on the angled portion of this part probably closer to the back.